Step 1
 |
King Size
With am California King Size frame, position the three boards
on the pedestal. Be sure the pedestal is equally recessed on
all four sides so that the weight of the waterbed may be
evenly distributed.
The cut corner(s) should be at the head of the bed so that
the waterbed heater wires may pass under the frame and be
plugged into an outlet. Do NOT install the heater at this
point.
If your corners are not cut, trim off a triangular piece of
the corner about 3" from the corner nearest the
electrical wall outlet using a small handsaw or jigsaw.
|
Step 2
 |
Queen Size
The California Queen size typically has three boards of two
sizes. Position the three boards on the pedestal with the
narrower board in the middle. Be sure the pedestal is equally
recessed on all four sides so that the weight of the waterbed
may be evenly distributed.
The cut corners should be at the head of the bed so that the
waterbed heater wires may pass under the frame and be plugged
into an outlet. Do NOT install the heater at this point. |
Step 3
 |
SuperSingle
The Super Single size typically has two boards. Position the
boards on the pedestal with the narrower board in the middle.
Be sure the pedestal is equally recessed on all four sides so
that the weight of the waterbed may be evenly distributed.
The cut corners should be at the head of the bed so that the
waterbed heater wires may pass under the frame and be plugged
into an outlet. Do NOT install the heater at this point. |
